CoonDawgs.com
http://coondawgs.com/forum/

Tail strippers
http://coondawgs.com/forum/viewtopic.php?f=51&t=147416
Page 1 of 1

Author:  aleague91 [ Fri Jan 13, 2012 12:50 am ]
Post subject:  Tail strippers

Is there any benifit to buying a $30 tail stripper vs a $8 one and just exactly how do you use em.

Author:  exforu [ Fri Jan 13, 2012 4:30 pm ]
Post subject:  Re: Tail strippers

i just use 2 nails put 1 on each side of tail and pull. i have never had any trouble like this been doing it for years.

Author:  LaBlueTickHunter32 [ Fri Jan 13, 2012 7:06 pm ]
Post subject:  Tail strippers

I use gut hook on skinning knife

Outdoor Hub mobile, the outdoor information engine

Author:  Arkansas Frog [ Fri Jan 13, 2012 8:06 pm ]
Post subject:  Re: Tail strippers

get you a flat piece steel 4" wide 5 " long bolt it to a work table, cut a V in it, put tail in V pull or use two bolts [like he said about nails] or buy a plastic one under 5 bucks.

Author:  Sand Hill Hounds [ Fri Jan 13, 2012 9:52 pm ]
Post subject:  Re: Tail strippers

Just use the clip for a hitch pin cost is about 30 cents when you are done you can clip it back on your belt and be ready for the next one.

Author:  rockcreek21 [ Sat Feb 04, 2012 5:08 pm ]
Post subject:  Re: Tail strippers

the woods is full or tail strippers.. i just use 2 green limbs one on each side of the tail. grip the strippers with the tail positioned in between ur middle and ring finger and yank the stripper one way and the base of the tail another way..

Author:  beckart03 [ Sun Feb 05, 2012 7:09 pm ]
Post subject:  Re: Tail strippers

I just skin tail half way down then grab around bone firmly and pull. Rarely mess up but fur buyers don't care about tails too much anyways

Outdoor Hub mobile, the outdoor information engine

Author:  bobbercrazy23 [ Wed Feb 15, 2012 12:59 pm ]
Post subject:  Re: Tail strippers

use 2 screw drivers put one one each side and grab the handles with one hand and the ends with other and pull

Author:  hsbdh [ Mon Apr 09, 2012 4:37 pm ]
Post subject:  Re: Tail strippers

i use my dog lead to pull them dont matter if done in woods or at home always comes out, just loop chane throgh ring put on tail bone and pull hide off. real easy way. oh i pull tail down about a inch and cut it off and pull it after hide is off.

Author:  LIL BOB [ Fri Jul 11, 2014 7:59 pm ]
Post subject:  Re: Tail strippers

So once the bone is out how would ya go bout curin it so it's good fer how ever long.


Sent from my iPhone using Ohub Campfire